YGM Series Suspension Mill

product introduce:Spring Cone Crusher is early equipment. According to different applications, there are three kinds of crushing chamber can be chose. Cone crusher with standard type chamber is used for medium crushing, medium type chamber is used for fine crushing, and short head type is used for ultra-fine crushing.

Applications:Aggregate field,concrete mixing plant,dry mortar plant desulfurization,quartz sand,etc.


Chat Online Leave Message


Spring Cone Crusher breaks material by squeezing or compressing it between convex and concave shaped surfaces covered by manganese as the wear surface. Normally used as the secondary or tertiary crusher, the cone crusher has been developed to crush high or medium hardness material, such as iron ore ,copper ore, limestone, quartz, granite, and sand stones, etc.


1、The spring cone crushers crushes by the change of the gap in the crushing cavity;

2、High reduction ratio, high performance, low power consumption, and uniform size products.

Working Principle

Cone crusher crushes materials by the working surface between the movable cone and fixed cone. So it is more advanced and efficient than jaw crusher. The movable cone is supported by spherical bearing and fixed on an hanging erect shaft which is set in the eccentric sleeve, and the sleeve is set on the stopping and pushing bearing. The movable cone and erect shaft are driven by the eccentric shaft sleeve together. The eccentric shaft sleeve is driven by horizontal shaft and fimbriated gear, and the wheel of the conveyor belt is driven by motor through v-belts. The lower part of vertical shaft is installed in the eccentric sleeve. When the eccentric sleeve rotates, there is a conical surface lined out by the shaft. When the movable cone comes near the fixed cone, rocks are grinded into pieces, when the movable cone leaves, grinded materials is discharged from the discharge hole. The fixed cone can be ascended or descended by adjusting setting to adjust the width of discharge hole, consequently the output size is determined adjusted.


Type Max. input (mm) Adjusting range of output (mm) Capacity (t/h) Motor power (kW) weight (t) Overall dimensions (L×W×H)(mm)
PYB 600 65 12-25 12-25 30(40) 5 2800×1300×1700
PYD 35 3-15 5-23 5.5
PYB 900 115 15-50 50-90 55(75) 8.8 3050×1640×2350
PYZ 60 5-20 20-65 8.8
PYD 40 3-13 15-50 9
PYB 1200 145 20-50 110-200 110(150) 24.7 4152×2300×2980
PYZ 100 8-26 50-150 25
PYD 50 3-15 18-105 25.6
PYB 1750 215 25-60 280-480 160(220) 50.3 4870×3800×4192
PYZ 185 10-30 115-320 50.3
PYD 85 5-15 75-230 50.4